Albino

This is the amelanistic / T- Albino mutation in Ball Pythons. It removes all black pigmentation and replaces them with white, leaving behind yellows and oranges, and also has a red eye. The first ball python mutation found in the hobby.
RGI Rates This:
A+
First Produced By:
Bob Clark Reptiles
First Produced In:
1992
Gene Type:
Recessive
Complex:
Available from These Vendors:
Get 15% off from our preferred vendors!
Order through RGI:

Additional References

Special Thank You to Our Supporters

We couldn't develop our tests without the support of the community. These breeders helped us by volunteering to send their sheds in for our research.
No items found.

About Our Test Grades

A+

Peer reviewed scientific paper detailing this mutation. Over 1000 homozygous, heterozygous, and normal samples have been run and match known genetics, and all known mutations are covered by our test. 

Expected accuracy for this test is over 99.9%.

A

Over 1000 homozygous, heterozygous, and normal samples have been run and match known genetics, and all known mutations are covered by our test. 

Expected accuracy for this test is over 99.9%.

B

Over 500 homozygous, heterozygous, and normal samples  have been run and match known genetics, and all known mutations are covered by our test. 

Expected accuracy for this test is over 99.5%.

C

Over 200 homozygous, heterozygous, and normal samples have been run and match known genetics over 99% of the time. To date our test accounts for all known mutations that cause this morph, but we are still looking to see if there are any signs that another mutation exists that causes this morph. 

Expected accuracy for this test is over 99%.

D

Over 100 homozygous, heterozygous, and normal samples have been run and match known genetics over 80% of the time for at least one mutation. An additional unmapped mutation may exist for this morph. Either way, we are still working to optimize this test so that it will cover all known mutations for this morph. 

Expected accuracy will vary and will be below 99% because not enough tests have been run at this time.

E

The design and optimization for this test is in its final stages, but no working test exists at this point. Projected time to having a working test should be less than 2 months, unless it ends up that more sampling and sequencing is needed.

At that point the test would move down to being a Grade F.

F

Sequencing is in progress and we expect to have a working test in 2-4 months, as long as more sampling and sequencing is not needed.